Dave Graffam has just released a Patrol boat model, basically a small skiff. I needed a break from my terrain building so I put one together. Dave releases all his models as layered PDF’s so you can get quiet a few different looking boats out of the one product. Dave does however include some print and go models ie no layers to tick on and off you just print and build. Unfortunately no GSD’s but there is something soothing about hand cutting a model now and again, I’m always surprised at how enjoyable I find hand cutting stuff.
The Patrol boat is a fairly simple model, there are a couple of free hand curves but nothing to worry about. I was able to cut out all the parts and edge them in about an hour and I had it fully assembled an hour after that. Assuming I can count the model consists of 16 parts, here are mine all cut out and ready to assemble:
I went with a blue theme so that it matched with my Pirate Bear Cog. Once you get all the parts cut out it’s a simple matter of gluing them together, make sure you follow Dave’s instructions as there are a couple of spots were if you glue things out of order you will be reprinting parts . Here is my finished patrol boat:
You may have noticed the little piece of string and magnet at the bow of my boat in the above picture. I made one little change and that was to add a small piece of metal to the base of the boat and place a magnet in the mast. This allows me to remove the mast for storage making the boat much easier to store:
It’s a great little boat and I plan on making 2 or 3 more. The only minor issue I have with the design is that the front sail is mounted offset, however I plan on adding a few little tabs to the sail on my next one and gluing these inside the mast through some slots I’ll cut , similar to how the rudder is mounted.
It’s a great little boat and well worth the $3.95 price tag Dave has on it.
I better get back to building the WWG terrain I’m doing.